control and switch panel for further information. Please refer to the operating instructions of the IT. Use the main V switch (see instruction manual of relevant control and switch panel) to switch on/off all the consumers and the control and switch panel BA / EN Date:Ĥ The following outputs are exceptions: loor light/step AES/compressor refrigerator Heater rost protection valve Spare 4 These outputs are not disabled via the main switch of the IT. 0) is set to the correct position for the battery installed. Ensure that the battery selector switch (ig. Therefore prior to starting: Ensure the leisure area battery is connected. Starting up the system Y ATTENTION! Incorrect electroblock settings. or this, an overvoltage protection unit is fitted in the electroblock between the mains connection and the charge module. or example, lightning strikes to the national grid, generator operation, poor electronic installations or trips to distance countries. Overvoltage protection OVP The EBL 9 with OVP electroblock is suitable for all applications in which the risk of overvoltage is particularly high. Settings only have to be carried out once if the battery type is changed (AGM or lead-gel), during initial start-up or when retrofitting accessories (see Section. or daily use, no operation is needed on the EBL 9 electroblock or EBL 9 with OVP (exception: the battery cut-off switch should be disabled when the vehicle is not in use, see Section.4). Operation The electroblock is operated solely via the IT. Children must be supervised to ensure they do not play with the device. Y This device is not intended to be used by those (including children) with limited physical, sensory or mental aptitude or lack of experience and/or knowledge unless they are supervised by a person responsible for their safety or have received instruction from this person as to how the device is used. All safety information must be passed on to other users.

The operating instructions should always be kept in the vehicle.

Make sure you read and follow the safety instructions provided. This instruction manual contains important information on safe operation of the device. temperature sensitive clothes if the device has been installed in a wardrobe) Date: BA / ENģ Introduction Y This device is intended solely for use in vehicles. Never store heat sensitive objects close to the device (e.g.

Risk of fatal injury due to electric shock or fire: Do not carry out maintenance or repair work on the device If cables or the device housing are damaged, no longer use the device and isolate it from the power supply Ensure that no liquids enter the device Y WARNING! Hot components Burns: Only change blown fuses when the device is fully de-energised Blown fuses may only be replaced once the cause of the fault is known and has been rectified Never bypass or repair fuses Only use original fuses rated as specified on the device Device parts can become hot during operation. Y DANGER! 0V units carrying mains voltage. Any faults affecting the safety of individuals or the proper functioning of the device must be repaired immediately by specialists. Only use the device when it is in perfect technical condition. ailure to observe the safety instructions may nonetheless lead to injury or damage to the device. General safety instructions The design of the device is state-of-the-art and complies with approved safety regulations. Y ATTENTION! ailure to comply with the sign may result in damage to equipment or other connected loads. Y WARNING! ailure to comply with this sign may result in injury. Meaning of safety symbols Y DANGER! ailure to comply with this sign may result in danger to life or physical condition. 0 E Schaudt GmbH, Elektrotechnik und Apparatebau, Planckstraße 8, Markdorf, Germany, Tel. Changing the battery Operating faults Closing down the system Application and functions in detail Battery functions Additional functions Maintenance. 1 Instruction Manual Electroblock EBL 9 EBL 9 with OVP Table of contents Safety information.

Download ebl 99 service manual